Skip to content

Practical guide

Thresholds and estimated value

Which threshold category a procurement falls into under Regulation 5, and how Regulation 6 requires its value to be estimated: options, renewals, lots, recurring contracts, the moment of calculation and the ban on splitting.

Updated 20 November 2026

Reviewed by Mara Ribeiro Duarte, Head of Public Sector at Closer · 20 November 2026

Legal basisRegulation 5 · Regulation 6(1) · Regulation 6(5) · Regulation 6(6) · Regulation 6(7) · Regulation 6(11)(b) · Regulation 6(13) · Regulation 6(14) · official text

Whether the Regulations apply to a purchase depends first on its value. They apply to procurements whose value, net of VAT, is estimated to be equal to or greater than the thresholds in Regulation 5 (Regulation 5), and Regulation 6 says how that estimate must be made. This guide sets out the threshold categories and the rules of calculation. The amounts are on the thresholds page: the figures in Regulation 5 as made have since been revised by the European Commission, and that page shows both.

The threshold categories

Regulation 5 sets a threshold for each of these categories (Regulation 5):

PointCategory
(a)Public works contracts (Regulation 5(a))
(b)Public supply contracts (subject to point (f)), public service contracts and design contests of central government authorities (Regulation 5(b))
(c)Public supply contracts, public service contracts and design contests of sub-central contracting authorities (Regulation 5(c))
(d)Public supply contracts awarded by a central government authority in the field of defence, where the products involve products not covered by Annex III to the Public Authorities Contracts Directive (Regulation 5(d))
(e)Public service contracts for social and other specific services listed in Annex XIV to that Directive (Regulation 5(e))
(f)Public supply contracts awarded by contracting authorities in the field of defence, but only where they concern products covered by Annex III (Regulation 5(f))

Two definitions decide between points (b) and (c). A central government authority is one specified in Annex I to the Public Authorities Contracts Directive, and a sub-central contracting authority is any contracting authority that is not a central government authority (Regulation 2(1)).

The type of contract follows the definitions of public works contract, public supply contract and public service contract in Regulation 2 (Regulation 2(1)). A contract that combines types is dealt with by Regulation 4, outlined in the guide on principles and economic operators.

Contracts for the social and other specific services of point (e) that reach that threshold are awarded under Chapter 1 of Part 3 (Regulation 74); see the guide on the light-touch regime.

Below the thresholds these Regulations do not apply. Above them, a contract may still fall outside the Regulations under one of the exclusions of Regulations 7 to 17; the guide on exemptions sets them out, and the two of those Regulations that work the other way.

The basic rule: the total amount payable

The estimated value is based on the total amount payable, net of VAT, as estimated by the contracting authority, including any form of option and any renewal of the contract as explicitly specified in the procurement documents (Regulation 6(1)). So an option to extend, an option to buy further quantities and a renewal clause provided for in the documents are counted in the estimate, not left out of it.

Where the contracting authority provides for prizes or payments to candidates or tenderers, it must take them into account as well (Regulation 6(2)).

Where a contracting authority is made up of separate operational units, the total estimated value for all those units is taken into account (Regulation 6(3)). The exception is a separate operational unit that is independently responsible for its procurement, or for certain categories of it: the value of that procurement may then be estimated at the level of the unit (Regulation 6(4)).

When the value is calculated

The estimated value is the value at the moment the call for competition is sent. Where no call for competition is foreseen, it is the value at the moment the contracting authority commences the procurement procedure, including, where appropriate, by contacting economic operators about the procurement (Regulation 6(7)).

An estimate made early in planning is therefore not the one that counts. If the scope, the term or the options change before the call for competition is sent, the estimate has to be made again on the new basis.

No splitting and no convenient method

Two rules stop a procurement from being taken outside the Regulations by the way it is valued or packaged:

  • the choice of the method used to calculate the estimated value must not be made with the intention of excluding the procurement from the scope of the Regulations (Regulation 6(5));
  • a procurement must not be subdivided with the effect of preventing it from falling within the scope of the Regulations, other than where the subdivision is justified by objective reasons (Regulation 6(6)).

The first rule turns on intention, the second on effect. A subdivision that keeps a procurement below the threshold is not allowed unless objective reasons justify it, whatever the purpose behind it.

The general principles point the same way: the design of a procurement must not be made with the intention of excluding it from the scope of the Regulations or of artificially narrowing competition (Regulation 18(2)).

Lots

Where a proposed work or a proposed provision of services may result in contracts being awarded in separate lots, the total estimated value of all the lots is taken into account (Regulation 6(11)(a)). If the aggregate value of the lots is equal to or greater than the relevant threshold, the Regulations apply to the awarding of each lot (Regulation 6(11)(b)).

The same applies where a proposal for the acquisition of similar supplies may result in contracts in separate lots. Their total value is taken into account when applying points (b), (c), (d) and (f) of Regulation 5, and if it reaches the relevant threshold the Regulations apply to each lot (Regulation 6(12)(a), Regulation 6(12)(b)).

There is one relief for small lots. A contracting authority may award contracts for individual lots without applying the procedures of the Regulations where both of these conditions are met (Regulation 6(13)):

  1. the estimated value, net of VAT, of the lot is less than €80,000 for supplies or services, or €1,000,000 for works (Regulation 6(13)(a)); and
  2. the aggregate value of the lots awarded without applying the Regulations does not exceed 20% of the aggregate value of all the lots into which the work, the acquisition of similar supplies or the provision of services has been divided (Regulation 6(13)(b)).

These are the figures as the Regulations state them. The guide on lots covers division into lots within the procedure itself.

Particular cases

Regulation 6 has specific rules for several kinds of contract:

SituationWhat is counted
Framework agreements and dynamic purchasing systemsThe maximum estimated value, net of VAT, of all the contracts envisaged for their total term (Regulation 6(8))
Innovation partnershipsThe maximum estimated value, net of VAT, of the research and development activities at all stages of the partnership and of what is to be developed and procured at its end (Regulation 6(9))
Public works contractsThe cost of the works plus the total estimated value of the supplies and services the contracting authority makes available to the contractor, where they are necessary for executing the works (Regulation 6(10))
Leasing, hire, rental or hire purchase of products, fixed term of 12 months or lessThe total estimated value for the term (Regulation 6(15)(a))
The same, fixed term of more than 12 monthsThe total value including the estimated residual value (Regulation 6(15)(a))
The same, no fixed term or a term that cannot be definedThe monthly value multiplied by 48 (Regulation 6(15)(b))
Insurance servicesThe premium payable and other forms of remuneration (Regulation 6(16)(a))
Banking and other financial servicesThe fees, commissions payable, interest and other forms of remuneration (Regulation 6(16)(b))
Design contractsThe fees, commissions payable and other forms of remuneration (Regulation 6(16)(c))
Service contracts with no total price, fixed term of 48 months or lessThe total value for their full term (Regulation 6(17)(a))
Service contracts with no total price, no fixed term or a term of more than 48 monthsThe monthly value multiplied by 48 (Regulation 6(17)(b))

The rules for insurance, banking and design services apply "where appropriate" (Regulation 6(16)). The guide on framework agreements and dynamic purchasing covers those techniques.

Regular and renewable contracts

For public supply or service contracts which are regular in nature, or which are intended to be renewed within a given period, the estimate is based on either of two figures (Regulation 6(14)):

  • the total actual value of the successive contracts of the same type awarded during the preceding 12 months or financial year, adjusted where possible for the changes in quantity or value expected in the 12 months following the initial contract (Regulation 6(14)(a)); or
  • the total estimated value of the successive contracts awarded during the 12 months following the first delivery, or during the financial year where that is longer than 12 months (Regulation 6(14)(b)).

The Regulation leaves the choice between them to the contracting authority, but the choice must not be made with the intention of excluding the procurement from the Regulations (Regulation 6(5)).

A working checklist

  1. Identify whether the contracting authority is a central government authority or a sub-central contracting authority (Regulation 2(1)).
  2. Identify the type of contract and, for supplies in the field of defence, whether the products are covered by Annex III to the Directive (Regulation 5).
  3. Add up everything payable, net of VAT: options and renewals, prizes and payments, all lots, and all operational units unless one is independently responsible (Regulation 6(1), Regulation 6(2), Regulation 6(3)).
  4. Apply the specific rule for the kind of contract, if there is one (the table above).
  5. Take the value at the moment the call for competition is sent or the procedure begins (Regulation 6(7)).
  6. Compare the result with the thresholds and check the exemptions.
  7. Keep a record: the contracting authority must document the progress of every procedure and justify the decisions taken at all its stages (Regulation 84(4)), and the report on each contract states its value (Regulation 84(1)(a)).

The FAQ on thresholds and scope answers the most common questions in short form.

Want your tender documents checked before publication? We will show you how Procurelex Check does it.

Request a demo

General information on the Public Authority Contracts Regulations 2016 in force. Not legal advice.